They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body in Nylon, allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must not exceed 70°C.
They are commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, approximately 4-5 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
Referencia: IMM63/A
Marca: SACEMI
SACEMI Electrobomba trifásica IMM 63A Son adecuadas para trasvasar líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete y espiral de nylon, cuerpo de la bomba de aluminio, permiten el uso con agua, emulsiones y sustancias aceitosas en general, con viscosidad no superior a 21 cSt (3° Engel). La temperatura del...
Referencia: SP25
Marca: SACEMI
SACEMI Electrobomba trifásica SP 25 Son adecuadas para el trasvase de líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete y espiral en PTB, cuerpo de la bomba en fundición, permiten utilizarlas con agua, emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3° Engel). La...
Referencia: 132POMP150090N
Marca: SAP
Electrobomba SAP PA 150 trifásica para máquinas herramienta Características y prestaciones Electrobomba específica para máquinas herramientaElectrobomba con aspiración sumergida sin juntas de estanqueidad.Versión trifásica tipo PA 150 y monofásica PA 150-MGrado de protección IP 54 contra la penetración de líquidos.Carcasa de aluminio extruido protegida...
Referencia: SPV18
Marca: SACEMI
SACEMI Electrobomba trifásica SPV 18 Son adecuadas para trasvasar líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete, espiral y cuerpo de la bomba en PBT permiten utilizarlas con agua, emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3° Engel). La temperatura del...
They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body in Nylon, allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must not exceed 70°C.
They are commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, approximately 4-5 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
