They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body in PBT allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must not exceed 70°C.
They are commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, about 3-4 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
Reference: SPV75
Brand: SACEMI
Three-phase electric pump SACEMI SPV 75 They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body in Nylon, allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid...
Reference: MPC100B
Brand: SACEMI
Three-phase electric pump SACEMI MPC 100B They are suitable for transferring liquids containing impurities up to 2 mm in size. The hydraulic components: brass impeller, aluminium scroll and pump body allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature...
Reference: AU63
Brand: SACEMI
Three-phase electric pump SACEMI AU63 They are suitable for transferring clean liquids containing impurities not exceeding 0.03 mm. The hydraulic components: brass impeller, cast iron backplate and aluminium pump body, allow them to be used with emulsions, oily substances and liquids in general as long as they are non-oxidising for the materials of...
Reference: IMM90/B
Brand: SACEMI
Three-phase electric pump SACEMI IMM 90B Suitable for transferring liquids containing impurities up to 4 mm in size. The hydraulic components: cast iron impeller and scroll, steel pump body, allow use with water, emulsions and oily substances in general, with viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 90°C....
They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body in PBT allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must not exceed 70°C.
They are commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, about 3-4 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
