They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body in PBT allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must not exceed 70°C.
They are commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, about 3-4 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
Reference: SPV50
Brand: SACEMI
Three-phase electric pump SACEMI SPV 50 They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body in Nylon, allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid...
Reference: EPC63C
Brand: SACEMI
Three-phase electric pump SACEMI EPC 63C They are suitable for transferring clean liquids containing impurities no larger than 0.03 mm. The hydraulic components: brass impeller, cast iron scroll and pump body, allow them to be used with emulsions and oily substances, glycols and liquids in general, as long as they are non-oxidising for the materials...
Reference: EPC71B
Brand: SACEMI
Three-phase electric pump SACEMI EPC 71B They are suitable for transferring clean liquids containing impurities no larger than 0.03 mm. The hydraulic components: brass impeller, cast iron scroll and pump body, allow them to be used with emulsions and oily substances, glycols and liquids in general, as long as they are non-oxidising for the materials...
Reference: SPV75
Brand: SACEMI
Three-phase electric pump SACEMI SPV 75 They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body in Nylon, allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid...
They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body in PBT allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must not exceed 70°C.
They are commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, about 3-4 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
