They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body in PBT allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must not exceed 70°C.
They are commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, about 3-4 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
Referencia: EPC80B
Marca: SACEMI
SACEMI Electrobomba trifásica EPC 80B Son adecuadas para trasvasar líquidos limpios que contengan impurezas no superiores a 0,03 mm. Los componentes hidráulicos: rodete de latón, voluta de fundición y cuerpo de bomba, permiten su utilización con emulsiones y sustancias aceitosas, glicoles y líquidos en general, siempre que sean no oxidantes para los...
Referencia: 132POMP150090N
Marca: SAP
Electrobomba SAP PA 150 trifásica para máquinas herramienta Características y prestaciones Electrobomba específica para máquinas herramientaElectrobomba con aspiración sumergida sin juntas de estanqueidad.Versión trifásica tipo PA 150 y monofásica PA 150-MGrado de protección IP 54 contra la penetración de líquidos.Carcasa de aluminio extruido protegida...
Referencia: IMM63/B
Marca: SACEMI
SACEMI Electrobomba trifásica IMM 63B Adecuada para trasvasar líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete y espiral de nylon, cuerpo de la bomba de aluminio, permiten el uso con agua, emulsiones y sustancias aceitosas en general, con viscosidad no superior a 21 cSt (3° Engel). La temperatura del líquido...
Referencia: MP100B
Marca: SACEMI
SACEMI Electrobomba trifásica MP 100B Adecuada para trasvasar líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete de latón, espiral y cuerpo de la bomba de aluminio, permiten su uso con agua, emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3° Engel). La temperatura del...
They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body in PBT allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must not exceed 70°C.
They are commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, about 3-4 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
