They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller and scroll in PTB, pump body in cast iron, allow use with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 70°C.
Commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, approximately 3-4 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
Referencia: AP112/B
Marca: SACEMI
SACEMI Electrobomba trifásica IMM 112B Adecuada para trasvasar líquidos que contengan impurezas de hasta 2 mm de tamaño. Los componentes hidráulicos: rodete y espiral de hierro fundido, cuerpo de la bomba de hierro fundido/acero permiten su uso con agua, emulsiones y sustancias aceitosas en general, con viscosidad no superior a 21 cSt (3° Engel). La...
Referencia: IMM100/B
Marca: SACEMI
SACEMI Electrobomba trifásica IMM 100B Adecuada para trasvasar líquidos que contengan impurezas de hasta 4 mm de tamaño. Los componentes hidráulicos: rodete y espiral de hierro fundido, cuerpo de la bomba de acero, permiten el uso con agua, emulsiones y sustancias aceitosas en general, con viscosidad no superior a 21 cSt (3° Engel). La temperatura del...
Referencia: 58POMPA35M085
Marca: SAP
Electrobomba SAP PA 35 monofásica para máquinas herramienta 180 mm de altura de aspiración Alimentación Monofásica Fabricante SAP Características y prestaciones Electrobomba específica para máquinas herramienta Bomba eléctrica con cabezal de aspiración sumergido sin juntas de estanqueidad. Versión monofásica tipo PA 35 Grado de protección IP 54 contra la...
Referencia: MSPV80
Marca: SACEMI
SACEMI Electrobomba trifásica MSPV 80 Son adecuadas para trasvasar líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete, espiral y cuerpo de la bomba fabricados en PBT permiten utilizarlas con emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3° Engel). La temperatura del...
They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller and scroll in PTB, pump body in cast iron, allow use with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 70°C.
Commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, approximately 3-4 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
