They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body made of PBT allow them to be used with emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 90°C.
They are commonly used on
They should normally be installed on a tank with a capacity proportionate to the flow rate, approximately 4-5 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
Referencia: IMM80/B
Marca: SACEMI
SACEMI Electrobomba trifásica IMM 80B Adecuada para el trasvase de líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete de latón, espiral y cuerpo de la bomba de aluminio, permiten su utilización con agua, emulsiones y sustancias aceitosas en general, con viscosidad no superior a 21 cSt (3° Engel). La...
Referencia: AP90/B
Marca: SACEMI
SACEMI Electrobomba trifásica AP 90B Adecuada para el trasvase de líquidos que contengan impurezas de hasta 2 mm de tamaño. Los componentes hidráulicos: rodete y espiral de hierro fundido, cuerpo de la bomba de hierro fundido/acero, permiten su uso con agua, emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3°...
Referencia: MPC100B
Marca: SACEMI
SACEMI Bomba eléctrica trifásica MPC 100B Adecuada para trasvasar líquidos que contengan impurezas de hasta 2 mm de tamaño. Los componentes hidráulicos: rodete de latón, voluta de aluminio y cuerpo de la bomba permiten su uso con agua, emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3° Engel). La temperatura...
Referencia: IMM63/A
Marca: SACEMI
SACEMI Electrobomba trifásica IMM 63A Son adecuadas para trasvasar líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete y espiral de nylon, cuerpo de la bomba de aluminio, permiten el uso con agua, emulsiones y sustancias aceitosas en general, con viscosidad no superior a 21 cSt (3° Engel). La temperatura del...
They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body made of PBT allow them to be used with emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 90°C.
They are commonly used on
They should normally be installed on a tank with a capacity proportionate to the flow rate, approximately 4-5 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
