Suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: brass impeller, scroll and aluminium pump body allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 90°C.
Commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, approximately 4-5 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
Referencia: SP18
Marca: SACEMI
SACEMI Electrobomba trifásica SP 18 Son adecuadas para el trasvase de líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete y espiral en PBT, cuerpo de la bomba en fundición, permiten utilizarlas con agua, emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3° Engel). La...
Referencia: EPC90A
Marca: SACEMI
SACEMI Electrobomba trifásica EPC 90A Son adecuadas para trasvasar líquidos limpios que contengan impurezas no superiores a 0,03 mm. Los componentes hidráulicos: rodete de latón, voluta de fundición y cuerpo de bomba, permiten su utilización con emulsiones y sustancias aceitosas, glicoles y líquidos en general, siempre que sean no oxidantes para los...
Referencia: MP63C
Marca: SACEMI
SACEMI Electrobomba trifásica MP 63C Son adecuadas para trasvasar líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete de latón, espiral y cuerpo de bomba de aluminio, permiten utilizarlas con agua, emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3° Engel). La...
Referencia: IMM71/A
Marca: SACEMI
SACEMI Electrobomba trifásica IMM 71A Son adecuadas para trasvasar líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete de latón, espiral y cuerpo de la bomba de aluminio permiten el uso con agua, emulsiones y sustancias aceitosas en general, con viscosidad no superior a 21 cSt (3° Engel). La temperatura del...
Suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: brass impeller, scroll and aluminium pump body allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 90°C.
Commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, approximately 4-5 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
