They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: brass impeller, scroll and aluminium pump body allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 90°C.
Commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, approximately 4-5 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
Reference: IMM63/B
Brand: SACEMI
Three-phase electric pump SACEMI IMM 63B Suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: nylon impeller and scroll, aluminium pump body, allow use with water, emulsions and oily substances in general, with viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must not exceed...
Reference: SPV50
Brand: SACEMI
Three-phase electric pump SACEMI SPV 50 They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body in Nylon, allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid...
Reference: SPV25
Brand: SACEMI
Three-phase electric pump SACEMI SPV 25 They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body in PBT allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must...
Reference: SQ56S
Brand: SACEMI
Three-phase electric pump SACEMI SQ 56/S They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: nylon impeller and cast iron scroll allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must...
They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: brass impeller, scroll and aluminium pump body allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 90°C.
Commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, approximately 4-5 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
