Suitable for transferring liquids containing impurities up to 2 mm in size. The hydraulic components: cast iron impeller and scroll, cast iron/steel pump body, allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 90°C.
Commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, approximately 6-7 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
Referencia: SPV12
Marca: SACEMI
SACEMI Electrobomba trifásica SPV 12 Son adecuadas para trasvasar líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete, espiral y cuerpo de la bomba en PBT permiten utilizarlas con agua, emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3° Engel). La temperatura del...
Referencia: EPC63C
Marca: SACEMI
SACEMI Electrobomba trifásica EPC 63C Son adecuadas para trasvasar líquidos limpios que contengan impurezas no superiores a 0,03 mm. Los componentes hidráulicos: rodete de latón, voluta de fundición y cuerpo de bomba, permiten utilizarlas con emulsiones y sustancias aceitosas, glicoles y líquidos en general, siempre que no sean oxidantes para los...
Referencia: IMM90/A
Marca: SACEMI
SACEMI Electrobomba trifásica IMM 90A Adecuada para trasvasar líquidos que contengan impurezas de hasta 4 mm de tamaño. Los componentes hidráulicos: rodete y espiral de hierro fundido, cuerpo de la bomba de acero, permiten el uso con agua, emulsiones y sustancias aceitosas en general, con viscosidad no superior a 21 cSt (3° Engel). La temperatura del...
Referencia: AU56
Marca: SACEMI
SACEMI Electrobomba trifásica AU56 Son adecuadas para trasvasar líquidos limpios que contengan impurezas no superiores a 0,03 mm. Los componentes hidráulicos: rodete de latón, placa posterior de fundición y cuerpo de la bomba de aluminio, permiten utilizarlas con emulsiones, sustancias aceitosas y líquidos en general siempre que no sean oxidantes...
Suitable for transferring liquids containing impurities up to 2 mm in size. The hydraulic components: cast iron impeller and scroll, cast iron/steel pump body, allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 90°C.
Commonly used on
They are normally installed on a tank with a capacity proportionate to the flow rate, approximately 6-7 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
