Suitable for transferring liquids containing impurities up to 4 mm in size. The hydraulic components: cast iron impeller and scroll, steel pump body, allow use with water, emulsions and oily substances in general, with viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 90°C.
They are commonly used on
They should normally be installed on a tank with a capacity proportionate to the flow rate, approximately 7-8 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 5-6 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
Reference: MP71A
Brand: SACEMI
Three-phase electric pump SACEMI MP 71A They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: brass impeller, scroll and aluminium pump body allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must...
Reference: SP75
Brand: SACEMI
Three-phase electric pump SACEMI SP 75 They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller and scroll in PTB, pump body in cast iron, allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature...
Reference: MSPV71
Brand: SACEMI
Three-phase electric pump SACEMI MSPV 71 They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body made of PBT allow them to be used with emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not...
Reference: SP50
Brand: SACEMI
Three-phase electric pump SACEMI SP 50 They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: impeller and scroll in PTB, pump body in cast iron, allow use with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not...
Suitable for transferring liquids containing impurities up to 4 mm in size. The hydraulic components: cast iron impeller and scroll, steel pump body, allow use with water, emulsions and oily substances in general, with viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 90°C.
They are commonly used on
They should normally be installed on a tank with a capacity proportionate to the flow rate, approximately 7-8 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 5-6 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
