They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: brass impeller, scroll and aluminium pump body allow use with water, emulsions and oily substances in general, with viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 90°C.
Commonly used on
They should normally be installed on a tank with a capacity proportionate to the flow rate, approximately 4-5 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
Referencia: SQ56S
Marca: SACEMI
SACEMI Electrobomba trifásica SQ 56/S Son adecuadas para trasvasar líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete de nylon y voluta de hierro fundido permiten utilizarlas con agua, emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3° Engel). La temperatura del...
Referencia: SP75
Marca: SACEMI
SACEMI Electrobomba trifásica SP 75 Son adecuadas para el trasvase de líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete y espiral en PTB, cuerpo de la bomba en fundición, permiten utilizarlas con agua, emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3° Engel). La...
Referencia: 58POMPA35M085
Marca: SAP
Electrobomba SAP PA 35 monofásica para máquinas herramienta 180 mm de altura de aspiración Alimentación Monofásica Fabricante SAP Características y prestaciones Electrobomba específica para máquinas herramienta Bomba eléctrica con cabezal de aspiración sumergido sin juntas de estanqueidad. Versión monofásica tipo PA 35 Grado de protección IP 54 contra la...
Referencia: SP18
Marca: SACEMI
SACEMI Electrobomba trifásica SP 18 Son adecuadas para el trasvase de líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete y espiral en PBT, cuerpo de la bomba en fundición, permiten utilizarlas con agua, emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3° Engel). La...
They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: brass impeller, scroll and aluminium pump body allow use with water, emulsions and oily substances in general, with viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 90°C.
Commonly used on
They should normally be installed on a tank with a capacity proportionate to the flow rate, approximately 4-5 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
