They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: nylon impeller and scroll, aluminium pump body, allow use with water, emulsions and oily substances in general, with viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must not exceed 70°C.
They are commonly used on
They should normally be installed on a tank with a capacity proportionate to the flow rate, approximately 4-5 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
Reference: MPC80B
Brand: SACEMI
Three-phase electric pump SACEMI MPC 80B Suitable for transferring liquids containing impurities up to 2 mm in size. The hydraulic components: brass impeller, aluminium scroll and pump body allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not...
Reference: MP80C
Brand: SACEMI
Three-phase electric pump SACEMI MP 80C They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: brass impeller, scroll and aluminium pump body allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must...
Reference: 132POMP150090N
Brand: SAP
Electric pump SAP PA 150 three-phase for machine tools Features and performance Specific electric pump for machine toolsElectric pump with submerged suction inlet without sealing rings.Three-phase version type PA 150 and single-phase PA 150-MIP 54 degree of protection against the penetration of liquids.Extruded aluminium casing protected by anodic...
Reference: 86POMPESE03
Brand: SAP
Construction electric pump SAP ES-E3 230V recirculation pump Submersible pump Power supply Single-phase Manufacturer SAP 100 % MADE IN ITALY!
They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: nylon impeller and scroll, aluminium pump body, allow use with water, emulsions and oily substances in general, with viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must not exceed 70°C.
They are commonly used on
They should normally be installed on a tank with a capacity proportionate to the flow rate, approximately 4-5 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
