They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: nylon impeller and scroll, aluminium pump body, allow use with water, emulsions and oily substances in general, with viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must not exceed 70°C.
They are commonly used on
They should normally be installed on a tank with a capacity proportionate to the flow rate, approximately 4-5 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
Referencia: SPV18
Marca: SACEMI
SACEMI Electrobomba trifásica SPV 18 Son adecuadas para trasvasar líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete, espiral y cuerpo de la bomba en PBT permiten utilizarlas con agua, emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3° Engel). La temperatura del...
Referencia: SP18
Marca: SACEMI
SACEMI Electrobomba trifásica SP 18 Son adecuadas para el trasvase de líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete y espiral en PBT, cuerpo de la bomba en fundición, permiten utilizarlas con agua, emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3° Engel). La...
Referencia: MP63C
Marca: SACEMI
SACEMI Electrobomba trifásica MP 63C Son adecuadas para trasvasar líquidos que contengan impurezas de hasta 3 mm de tamaño. Los componentes hidráulicos: rodete de latón, espiral y cuerpo de bomba de aluminio, permiten utilizarlas con agua, emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3° Engel). La...
Referencia: AP90/A
Marca: SACEMI
SACEMI Electrobomba trifásica AP 90A Adecuada para el trasvase de líquidos que contengan impurezas de hasta 2 mm de tamaño. Los componentes hidráulicos: rodete y espiral de hierro fundido, cuerpo de la bomba de hierro fundido/acero, permiten su uso con agua, emulsiones y sustancias aceitosas en general, con una viscosidad no superior a 21 cSt (3°...
They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components: nylon impeller and scroll, aluminium pump body, allow use with water, emulsions and oily substances in general, with viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must not exceed 70°C.
They are commonly used on
They should normally be installed on a tank with a capacity proportionate to the flow rate, approximately 4-5 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments to allow the sludge to settle before it is pumped out of the pump.
SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS
